Rowmark Australia Blog | Surface Engraving

Corys Cutter Corner picture

Surface Engraving (including Burnishing and Diamond Drag)

 

 

 

Burnishing

Burnishing pictureBurnishing is a surface marking technique intended for coated metals – usually lacquered brass where the coating is removed to expose the bare metal. It is a method of rotary engraving on metals that tends to bridge the gap between diamond drag (scratch engraving) and routing.

 

Application

The most common application is on the brass plates or trophies and plaques. Burnishing can also be done on materials other than brass. However, much of the success or failure depends on the hardness of the material. Since burnishing is a surface marking technique, it is critical that the tip of the burnishing tool does not penetrate the surface of the material by an appreciable amount.

 

Burnishing Tools

The tool used for burnishing is called a “burnisher” which is a rotating tool that is used in a motorized spindle. It is usually a carbide or carbide-tipped tool that is ground with four facets. Two of the facets form an angled chisel edge on the center of the tool.

Engraving Cutter

Engraving Cutter

Carbide Burnisher

Carbide Burnisher

Diamond Burnisher

Diamond Burnisher

Diamond Graver

Diamond Graver

 

Process

Since the purpose of burnishing is to remove the coating from the surface a the material, the key to achieving successful results lies in the amount of downward pressure that is exerted on the tool. A burnishing tool is not a cutter and if too much pressure is applied, the tool will be forced into the material resulting in a rough, ragged stroke. Ideally, the tip of the tool should “float” over the surface with only enough pressure to remove the coating without digging into the metal.

Burnishing example pic

 

Your voice is extremely valuable, that is why we would love hearing from you on our Comments section below. It will help us offer you more rowmarkable experiences.

Previous article Rowmark Australia Blog | Product Highlights | LaserGlow
Next article Rowmark Australia Blog | Mr Tulk